P216-20M-340 PowerGrip HTD SprocketsPowerGrip HTD Sprockets are engineered specifically for use with your Gates PowerGrip HTD belts. Full split in bushing allows for easy installation and removal. Precise sprocket design produces positive, press fit to shaft. Precision manufactured and static balanced to eliminate sprocket wobble. Warning: Do not use these sprockets with rim speeds in excess of 6,500 fpm.

Provides greater axial holding power than set screw collars

• Can be used by hand or for tapping under power

Tempered wire 0

Note: This is the spec sheet for the All Stainless version

Greenback's™ nylon Easy Trim backing allows you to shave off the green backing as the flaps wear down exposing more flap length

tight run out spec

• Produces overlapping and interrupted holes easily

Polyurethane tubing offers increased flexibility

The Lock-On Chucks enable the user to attach and lock the chuck onto a tire valve

Robust carbon tensile cord combines minimal stretch with extraordinary strength while absorbing shock and surge loads

Spool Design

Optimal weight delivers the right resistance against the floor to get the job done better and faster