4 x 4R7 Ballast ResistorFor use with low impedance injectors. Compatible with injectors with impedance between 2 and 6 Ohms. Please contact us if you are planning on using injectors with an impedance of less than 2 ohms. Includes set of 4 x 4. 7ohm 25w resistors mounted to a heatsink. These are also sold in a set of 6. Note that injector ballast resistors get quite hot at high injector duty cycles. These should stay mounted on the supplied heat sink and be bolted to the

Common uses include: wasted spark on 6 cylinder engines

Can now power up via the USB cable

*DI 9 & 10 pins used by second CAN Bus

2 Ignition 2

immune to variations of pressure

pins and rubber boot

DI7 Digital Input

Using Link G4/G4+/G4X ECU’s just select the MAP sensor type in PC Link as ‘Link 4 Bar’

Boost control referenced to gear

The number of extra inputs and outputs added by the XS Loom is dependent on the Plugin ECU

The XS Loom is 2

Link G4 RX