Twin ferrule connectors and associated tubing for 316 stainless steel systems. Specification and test methods1 Scope This British Standard specifies the characteristics of, and performance requirements for, the tube connector (compression) end(s) of twin ferrule connectors made of 316 stainless steel. It also specifies requirements for 316 stainless steel tubes. The twin ferrule connectors in this standard are suitable for use with annealed stainless steel tubes with outside diameters from 2 mm to 38 mm and 1 16 in to 2 in. This British Standard is

to limit the rate of heat release from the vehicle on flash-over

This document also specifies requirements for equipment used to mix acid and bicarbonate powders into concentrate at the user's facility

specifications or codes

A valve can be specified

Only the tip of an insulated screwdriver is exposed

initially on that element and then on its particular part of the larger system

BS EN 13157 specifies requirements for the following hand powered lifting equipment defined in clause 3:

Who is BS EN 10341—Steel sheet and strip for

Contents of BS EN 60335-2-8:

Companies claiming compliance with code of practices for keyholding

Note: The titles of the publications referred to in BS 7462 are listed on the inside back cover

and maturity of your environment management system