Shrink chuck 4,5° SK 40 - 05 - 80Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

Double-clamping via two mobile and one fi xed jaw

Calibration certificat

For mounting straight-shank tools in collet chucks ISO 15488 (ex

and other hard to reach portions

For mounting straight-shank tools in collet chucks DIN 6499

rack and handles

6 stepped block pairs (12 pcs)

For mounting straight-shank tools

A possible increase of axial force during the tapping process is reduced to a minimum

Resolution:

Not applicable with reductions

20 mm only with reduction sleeve)