Belt drives. Dynamic test to determine pitch zone location - V-ribbed belts1 Scope This part of ISO 8370 specifies a dynamic method of determining the location of the pitch zone of a Vribbed belt, which is expressed as an effective line differential be (see figure 1). NOTE 1 If a high precision is not required, nominal values for the pitch zone positions given in ISO 9981 and ISO 9982 may be used.

This standard gives recommendations for facility management briefing to ensure that design takes account of the expected performance of the facility in use

General technical requirements are given in ISO 5743

Determination of urea condensates enables the quantitative determination of these condensates and the determination of the solubility of the MU-oligomers according to the Regulation

as well as stand-alone software for use in laptop or tablet computers

By applying

Note 2: The method is not applicable when the ply surfaces contain sharp bends

Lower limb orthoses manufacturers

ISO 16938‑1 on building and civil engineering works are applicable to:

indoor and outdoor small cell product compliance assessment using SAR measurements

Why should you use BS EN 3952- Silver base alloy AG-B10001 for aerospace series

7 Other aspects of ventilation

Why should you use BS EN 14258 - Structural adhesives