C170M-75X95 Locking AssemblySingle taper, self centering design with mounting flange for use in through bored components with smaller pitch outside diameters. Mounted component remains fixed axially during installation. View Catalog PageInstallation & Removal Instructions

Mounted component remains fixed axially during installation

Ideal for wash down applications in wet or harsh environments or where sanitary conditions are a factor

Clamping coupling portion will not mar the shaft

Design fully engages the shaft without marring

Traditional cost effective rigid coupling design

Self-lubricating bearings resist corrosions

Provides greater axial holding power than set screw or one-piece clamping collars

Collars include stainless steel screws

Drop-in replacement for commonly used hex nut keyless bushings

Effective on both hard and soft shafts

Two-piece stainless steel housing units

One-Piece Housing has rust-proof plated finish